Tungsten carbide is a material with high hardness, high wear resistance and high corrosion resistance, so special maintenance measures are required to prolong its service life. The following are some common carbide maintenance methods: 1. Avoid excessive wear. Carbide is commonly used to make knives and components, so be sure to avoid excessive wear.
When using the tool, pay attention to the direction, speed and angle to avoid damage to the cutting surface. 2. Avoid mechanical damage. Cemented carbide is susceptible to mechanical damage, such as knocking, bending, etc. Therefore, try to avoid such damage when using and storing cemented carbide products. 3. Pay attention to cleanliness. After using cemented carbide products, it should be cleaned in time, especially pay attention to cleaning the cutting surface. Special solvents or cleaning solutions can be used for cleaning, but do not use strong acid or alkaline solutions. 4. Suitable for storage. When storing cemented carbide products, care should be taken to avoid extrusion, collision or excessive humidity.
Tungsten carbide products can be sealed in plastic bags and stored in a dry place. 5. Periodic inspection. Regularly check the surface condition and cutting performance of cemented carbide products. If any damage or performance degradation is found, it should be replaced or repaired in time. In short, the maintenance of cemented carbide needs to pay attention to many factors. Only with correct maintenance can it exert its maximum performance and service life.
Post time: May-24-2023
